Stay connected

DriveControl 54


Product Description
The DriveControl 54 is the all-purpose interface for the RollerDrive EC310. 15 different speeds, as well as the direction of rotation, can be set using DIP switches. Optically decoupled digital I/O's act as the interface to a higher-order controller. This enables, for instance, the direction of rotation of the 7 different speeds to be set from a PLC. The braking energy of the RollerDrive is fed back into the 24 V grid. The voltage fed back from the RollerDrive EC310 is limited at 30 V by means of the integral brake chopper (voltage-dependently switched load resistance).

DriveControl DC54

Functions
  • Speed adjustment (15 speeds internally, 7 speeds externally via I/O)
  • Choice of rotational direction
  • Start signal input (visually decoupled)
  • Rotational direction signal input (visually decoupled)
  • Fault signal output (visually decoupled)
  • LED status display
  • NPN or PNP switching logic
  • Sealed cable openings

Technical Data
Electrical data  
Rated voltage
 24 VDC
Voltage range
 18 to 26 VDC
Permissible voltage undulation
 3 %, recommended: < 1 %
Max. continuous current
 2.0 A
Max. start-up current
 5.0 A
Fuse
 present, non-replaceable
Protection classification
 IP54
Ambient conditions  
Ambient temperature in operation
 -28 to +40 °C
Ambient temperature during transport and storage
 -30 to +80 °C
Max. temperature change
 1 % in 3 h; 2 cycles in compliance with IEC 60068-2-14
Max. air humidity
 90 %, non-condensing
Cable cross-sections
Power Supply Fine-wired, 1.5 mm² (AWG 16)
Inputs / Outputs (I/O) Fine-wired, 0.08 to 0.5 mm² (AWG 28 to 20)
Fine-wired, 1.5 mm² (AWG 16)

The effective current in the application depends on the conveyor weight, conveyor speed and number of cycles.

The DriveControl for RollerDrive EC310

pdfUser Manual DriveControl 20+54
top
© Interroll | Sitemap | Disclaimer