Stay connected

DriveControl DC-EC100


Product Description

The DriveControl DC-EC100 meets all of the control and safety functions required to incorporate the RollerDrive EC100 simply and easily into a number of different applications. Using a heat model, the motor temperature is determined and monitored from the power permanently applied. The speed can be adjusted by means of an external analogue signal. The DriveControl is also equipped with a potentiometer, with which the speed can be set. All of the signals are referenced to the supply earth voltage.



Functions
  • Commutation electronics for RollerDrive EC100
  • Overload protection of the RollerDrive by the temperature model of the motor
  • Speed controller
  • Interface to external controls
  • Two inputs permit choice of rotational direction
  • Fault indication by LEDs
  • NPN or PNP signal logic
  • Sensor voltage supply
  • No accumulation logic (ZPA)
Technical Data
Electrical data  
Rated voltage
 24 VDC
Voltage range
 22 to 28 VDC
Permissible voltage undulation
 < 5 %, recommended: < 1 %
Max. continuous current
 1.8 A
Max. start-up current
 4.1 A
Fuse
 5 A, slow-blow
Protection classification
 IP20
Ambient conditions  
Ambient temperature in operation
 0 °C to 40 °C (32°F to 104°F)
Ambient temperature during transport and storage
 -20°C to 75°C (-4°F to 167°F)
Max. temperature change
 1 % in 3 h; 2 cycles in compliance with IEC 68-2-14
Ambient humidity
 90 %, non-condensing
Installation altitude above sea level max. 1000m (max. 3300ft)

The DriveControl for RollerDrive EC100

pdfUser Manual Interroll DriveControl DC-EC100
top
© Interroll | Sitemap | Disclaimer