RollerDrive EC110



RollerDrive EC110 has the most torque in the whole product line. It was developed specifically under the aspect of increased efficiency, to enable 24 VDC conveyor systems to work with less energy since ever.
Based on the design of the EC100 there are eight different gear ratios to chose from.
Even heaviest loads can be moved reliably with a mechanical performance of 31 Watts.



Characteristics
  • 31 Watt continuous mechanical performance
  • External commutation electronic
  • 8 gear ratios
  • After run reducing motor stop function
  • Zero motion hold for declines
  • 15.000 hours minimum operation time
  • Protection rate IP54
  • 55 dB(A) noise emission mounted in conveyor
  • 1000 mm cable length
  • 8 pole Tyco connector

User Manual Interroll RollerDrive EC100 and EC110

Electrical Data EC110
Nominal voltage
 24 VDC
Voltage range 22 - 28 VDC
No load current 0.6 A
Maximum continuous current 2.5 A
Maximum peak current
 4.1 A
Mechanical Performance 31 W
Maximum ripple from power supply
 5 %
Noise emission (mounted)
 55 dB(A)
Lifetime under nominal conditions 15000 h
System Efficiency (Drive) 52 %

Performance Data EC100

Gear Ratio
 Speed Range
m/s 		Nominal Torque
Nm 		Peak Torque
Nm
4 2.41 - 0.80 0.3 1.2
9 1.07 - 0.36
 0.8 2.6
12 0.80 - 0.26 1 3.5
16 0.60 - 0.20 1.5 4.2
24 0.40 - 0.13 2.2 5.8
36 0.27 - 0.09 2.9 9.2
48 0.20 - 0.07 3.4 11.5
64 0.15 - 0.05 4.3 13.2

Minimum RL

CartridgeTubeIdler bearingMin RL
4:1to 24:1 No groove 11 mm hexagonal end drilled and tapped M8 249
No groove 11 mm hexagonal spring loaded 292
No groove PolyVee end drilled and tapped M8 274
No groove PolyVee 11 mm hexagonal spring loaded 285
No groove Timing belt/3/8" chain end drilled and tapped 266
Groove30 60 11 mm hexagonal end drilled and tapped M8 292
Groove 50 80 11 mm hexagonal spring loaded 308
36:1to 64:1 No groove 11 mm hexagonal end drilled and tapped M8 258
No groove 11 mm hexagonal spring loaded 301
No groove PolyVee end drilled and tapped M8 283
No groove PolyVee 11 mm hexagonal spring loaded 294
No groove Timing belt/3/8" chain end drilled and tapped 275
Groove 30 60 11 mm hexagonal end drilled and tapped M8 301
Groove 50 80 11 mm hexagonal spring loaded 317
The minimum RL is determinate by the idler bearing and grooves. Maximum RL: 1500 mm.

DriveControl for EC110 RollerDrives
HC-EC100/110
                                    


top
© Interroll | Disclaimer