DriveControl DC-EC100



Basic information

The DriveControl DC-EC100 fulfills all commutation- and safety function which are required to install RollerDrive EC100 into a wide variety of applications.
Utilizing a heat model of the motor, the currant is monitored at any time to prevent overheating or damage in stall conditions.
By using an external analog signal (0-5 V) the speed can be adjusted from a PLC.
It is also possible to fine adjust the speed by using the on board potentiometer.
All signals for the DC-EC100 require common ground.
 


Functions
  • Commutation electronic for RollerDrive EC100
  • Overload protection of motor
  • Speed controller
  • Interface to upper level controls
  • Direction setting with two inputs
  • Failure output
  • Logic conversion NPN PNP
  • Sensor power supply and
  • Protection rate IP20

User Manual Interroll DriveControl DC-EC100
top
© Interroll | Disclaimer