Z-Card



Basic information

As a four zone controller the Z-Card allows the setup of a high flexible zero pressure accumulation conveyor system with RollerDrive EC200/300 or BT100 in a through going protection rate of IP54.
Z-Card comes with all necessary cables and plugs go connect RollerDrive, sensors and power supply.
 


Functions
  • Zero pressure accumulation control for up to four zones
  • Speed control by rotary switch
  • Interface to higher level controls by optical isolated I/Os
  • Failure output
  • Logic conversion NPN/PNP
  • Protection rate IP54

There are two different versions of Z-Card:

1- Z-Card BT, RollerDrive BT100 with a special cable version which includes a plug is directly connected. A very convenient and proven solution for conveyors with fewer throughputs.
(BT100 with Z-Card BT only with M12 on 11 mm hexagonal on motor side, no end drill and tapped, due to preassembled connector)

2- Z-Card EC, RollerDrive EC200/300 is directly connected with an extension cable.
There is no need for DC-EC200/300. RollerDrive EC100/110 can also be connected; however the
DC-EC100 or HC-EC110 is needed due to the external commutation setup.

The configuration for different conveyer modes is done by a rotary- and slide switch. There are different parameters which must be set up:
  • Number of RollerDrives/Zones connected
  • Single- or train release
  • Single release with PLC stop option
  • Motor starter without any ZPA logic
Applications

Z-Card is the best fit for lager conveyor systems with zero pressure accumulation logic.
Due to the Protection rate of IP54, Z-Card can be installed everywhere in the system without the need for additional housing.  Also the pre-manufactured cable set makes the installation very quick.
Typical applications are postal- and package handling and similar distribution centers.
top
© Interroll | Disclaimer