RollerDrive EC100



RollerDrive EC100 is the first choice for medium to heavy applications. With external commutation electronic and mechanical performance of 18 Watts, EC100 is a proven and stable solution for many different types of conveyors.
Speed selection takes place by picking one of the seven available gear ratios. On the external control board it is also possible to fine adjust the speed via a potentiometer.
There will be no loss of torque because EC100 uses a closed loop controller. For decline conveyor applications the EC100 is equipped with a zero motion hold electronic brake.
This keeps the packages on decline conveyors in place and prevents drifting.




Characteristics
  • 18 Watt continuous mechanical performance
  • External commutation electronic
  • 7 gear ratios
  • After run reducing motor stop function
  • Zero motion hold for declines
  • 15.000 hours minimum operation time
  • Protection rate IP54
  • 55 dB(A) noise emission mounted in conveyor
  • 800 mm cable length
  • 8 pole Tyco connector

User Manual Interroll RollerDrive EC100

EC100 Electrical Data
Nominal voltage 24 VDC
Voltage range 22 - 28 VDC
No load current 0.6 A
Maximum continuous current 1.8 A
Maximum peak current 4.1 A
Mechanical Performance 18 W
Maximum ripple from power supply 5%
Noise emission (mounted) 55 dB(A)
Lifetime under nominal conditions 15000 h
System Efficiency (Drive)
 42 %

EC100 Speed/Load Performance Data

Gear Ratio Nominal Speed
m/s
 Nominal Torque
Nm
 Peak Torque
Nm
12 1.32-0.44
 0.37
 1.4
16 1.03-0.34
 0.48
 1.8
24 0.69-0.22
 0.75
 2.8
36 0.44-0.15
 1.17
 3.8
48 0.35-0.12
 1.24
 5
64 0.25-0.08
 1.82
 6.1
96 0.17-0.06
 3
 11.3

Minimum RL

CartridgeTubeIdler bearingMin RL
12:1 to 24:1 No groove 11 mm hexagonal end drilled and tapped M8 233
No groove 11 mm hexagonal spring loaded 276
No groove PolyVee end drilled and tapped M8 258
No groove PolyVee 11 mm hexagonal spring loaded 269
No groove Timing belt/3/8" chain end drilled and tapped 250
Groove 30 60 11 mm hexagonal end drilled and tapped M8 276
Groove 50 80 11 mm hexagonal spring loaded 292
36:1 to 96:1 No groove 11 mm hexagonal end drilled and tapped M8 242
No groove 11 mm hexagonal spring loaded 285
No groove PolyVee end drilled and tapped M8 267
No groove PolyVee 11 mm hexagonal spring loaded 278
No groove Timing belt/3/8" chain end drilled and tapped 259
Groove 30 60 11 mm hexagonal end drilled and tapped M8 285
Groove 50 80 11 mm hexagonal spring loaded 301
The minimum RL is determinate by the idler bearing and grooves. Maximum RL: 1500 mm.

DriveControl for EC100 RollerDrives
DC-EC100
                                       
HC-EC100/110

top
© Interroll | Disclaimer